EMT Practice Test

1. Question Content...

---

Question1: Which statement is true about an alarm in a Suppressed state?

Question2: Which command is used to display the network configuration of the Tunnel Endpoint (TEP) IP on a bare metal transport node?

Question3: Which two statements describe the characteristics of an Edge Cluster in NSX? (Choose two.)

Question4: Which of the following exist only on Tler-1 Gateway firewall configurations and not on Tier-0?

Question5: An administrator has been tasked with implementing the SSL certificates for the NSX Manager Cluster VIP.
Which is the correct way to implement this change?

Question6: Which two tools are used for centralized logging in VMware NSX? (Choose two.)

Question7: Which component is required to use VMware Distributed vSwitches (vDS)?

Question8: Where does an administrator configure the VLANs used in VRF Lite? (Choose two.)

Question9: An administrator needs to encrypt file transfers between two sites that do not have the same subnet. Which NSX-T feature accomplishes this task?

Question10: Which of the two following characteristics about NAT64 are true? (Choose two.)

Question11: What needs to be configured on a Tier-0 Gateway to make NSX Edge Services available to a VM on a VLAN-backed logical switch?

Question12: An NSX administrator is creating a NAT rule on a Tier-0 Gateway configured in active-standby high availability mode.
Which two NAT rule types are supported for this configuration? (Choose two.)

Question13: An NSX administrator is creating a Tier-1 Gateway configured in Active-Standby High Availability Mode. In the event of node failure, the failover policy should not allow the original failed node to become the Active node upon recovery.
Which failover policy meets this requirement?

Question14: Where in the NSX UI would an administrator set the time attribute for a time-based Gateway Firewall rule?

Question15: A customer is planning to utilize NSX-T Data Center security services while maintaining current security services providers.
Which two features can help the customer achieve this kind of integration? (Choose two.)

Question16: How is the RouterLink port created between a Tier-1 Gateway and Tier-0 Gateway?

Question17: What are two valid BGP Attributes that can be used to influence the route path traffic will take?
(Choose two.)

Question18: A customer is preparing to deploy a VMware Kubernetes solution in an NSX environment.
What is the minimum MTU size for the UPLINK profile?

Question19: A customer has experienced a disaster. Which statement describes a recovery benefit of a vSphere Environment with NSX Data Center?

Question20: Which command is used to set the NSX Manager's logging-level to debug mode for troubleshooting?

Question21: Which two statements are correct about East-West Malware Prevention? (Choose two.)

Question22: Which CLI command on NSX Manager and NSX Edge is used to change NTP settings?

Question23: Which troubleshooting step will resolve an error with code 1001 during the configuration of a time- based firewall rule?

Question24: Which two statements are true about IDS Signatures? (Choose two.)

Question25: What are two functions of the Service Engines in NSX Advanced Load Balancer? (Choose two.)

Question26: Which three data collection sources are used by NSX Network Detection and Response to create correlations/Intrusion campaigns? (Choose three.)

Question27: What should an NSX administrator check to verify that VMware Identity Manager integration is successful?

Question28: Which two BGP configuration parameters can be configured in the VRF Lite gateways? (Choose two.)

Question29: Which tool could be used to configure BGP on a Tier-0 Gateway?

Question30: Drag and Drop Question
Match the NSX Intelligence recommendations with their correct purpose.

Question31: Which two logical router components span across all transport nodes? (Choose two.)

Question32: An administrator has connected two virtual machines on the same overlay segment. Ping between both virtual machines is successful.
What type of network boundary does this represent?

Question33: Which two choices are use cases for Distributed Intrusion Detection? (Choose two.)

Question34: Which three DHCP Services are supported by NSX? (Choose three.)

Question35: Which two of the following features are supported for the Standard NSX Application Platform Deployment? (Choose two.)

Question36: Which two steps must an NSX administrator take to integrate VMware Identity Manager in NSX to support role-based access control? (Choose two.)

Question37: Which table on an ESXi host is used to determine the location of a particular workload for a frame- forwarding decision?

Question38: In an NSX environment, an administrator is observing low throughput and congestion between the Tier-0 Gateway and the upstream physical routers.
Which two actions could address low throughput and congestion? (Choose two.)

Question39: Which NSX CLI command is used to change the authentication policy for local users?

Question40: Which command on ESXi is used to verify the Local Control Plane connectivity with Central Control Plane?

Question41: Which two are requirements for FQDN Analysis? (Choose two.)

Question42: An NSX administrator is reviewing syslog and notices that Distributed Firewall Rules hit counts are not being logged.
What could cause this issue?

Question43: Which three of the following describe the Border Gateway Routing Protocol (BGP) configuration on a Tier-0 Gateway? (Choose three.)

Question44: Which choice is a valid insertion point for North-South network introspection?

Question45: An administrator has a requirement to have consistent policy configuration and enforcement across NSX instances.
What feature of NSX fulfills this requirement?

Question46: Which steps are required to activate Malware Prevention on the NSX Application Platform?

Question47: An NSX administrator is troubleshooting a connectivity issue with virtual machines running on an ESXi transport node.
Which feature in the NSX UI shows the mapping between the virtual NIC and the host's physical adapter?

Question48: Which of the following statements is true regarding the use of a Dynamic Routing Protocol on a Tier-1 Gateway?

Question49: Which three selections are capabilities of Network Topology? (Choose three.)

Question50: An administrator needs to download the support bundle for NSX Manager.
Where does the administrator download the log bundle from?

Question51: Which two are supported by L2 VPN clients? (Choose two.)

Question52: Hotspot Question
Refer to the exhibit. Which two items must be configured to enable OSPF for the Tier-0 Gateway in the image? Mark your answers by clicking twice on the image.

Question53: Which two choices are solutions offered by the VMware NSX portfolio? (Choose two.)

Question54: An NSX administrator would like to create an L2 segment with the following requirements:
- L2 domain should not exist on the physical switches.
- East/West communication must be maximized as much as possible.
Which type of segment must the administrator choose?

Question55: Which VPN type must be configured before enabling an L2VPN?